Contact Person : Cindy Feng
Phone Number : 13711423085
WhatsApp : +13925187195
January 24, 2020
Wall Hung Basin Installation Instruction
1. Drill Some Holes In The Required Position On The Wall Using A 14mm Masonry Drill Bit To A Depth Of 75mm
2. Push A Wall Plug Into Each Hole
3. Screw A Fixing Bolt Into Each Fixing Plug Using A 8mm Spanner Until Spanner Contacts The Wall
4. Place The Basin In Position Against The Wall ,Locating The Fixing Bolts Through The Holes In The Rear Of The Basin.Push A Plastic Washer,Followed By A Metal Washer,Onto Each Fixing Bolt
5. Screw A Metal Nut Onto Each Fixing Bolt To Secure The Basin.Caution:Do Not Over Tighten As This May Damage The Materials.
Note:These Fixings Are Suitable For Solid Walls Only.Plasterboard Or Stud Walls May Require Specialist Fixings(Not Supplied).
Caution :Care Should Be Taken When Drilling Walls And Floors Avoid Any Wires Or Pipes.
Enter Your Message